Injection molding machine replacement hydraulic oil precautions

First, turn off the machine switch and stir the oily sediment with a wooden stick.

The second step is to drain all the hydraulic oil.

Step 3, remove the filter again, shine a flashlight into the space, and then use a clean towel or oil absorbent cloth to dry all the oil inside. Big robots crawl in and wipe.

The 4th step, clean filter, clean with diesel oil, brush the smeary on clean net wall with tooth brush, if discover to have broken filter net to want to buy afresh change, clean finish to rinse with clean diesel oil again next, however

Stand back and let the oil run dry.

The 5th pace, install strainer, the new oil that draws clean how many litre see the scale on the side, until reach standard scale, install good cover next, close switch actuate machine after about 1 minute, do manual

Mold about 5 times can be turned on heating to work.

youngstrong
Dongguan Taiwang Machinery Co.,LTD
Add:NO.127,longyan road,Chongkou Industrial district,Dongguan city,China.
Wedsite:www.twmachines.com
Mobile:86-13829239482
Tel:86-769-81701081
Email:[email protected]